Error in calculation stage.

[gdib]

Hello,
I am using Salome 7.2.0 (because I have Ubunto 15.04 with 32 bit) and Code_saturne 4.2. I am doing Tutorial 1: Shear Driven Cavity Flow.
I am exporting the mesh as CGNS file. I tried also for MED file.
I am just following the tutorial step by step. And I had this error.


****************************
Preparing calculation data
****************************

Single processor Code_Saturne simulation.


***************************
Preprocessing calculation
***************************


**********************
Starting calculation
**********************

solver script exited with status 1.

Error running the calculation.

Check Code_Saturne log (listing) and error* files for details.


****************************
Saving calculation results
****************************

Error in calculation stage.

Can you help me ? Thanks a lot

[gdib]

Now I tried '' sudo ldconfig ''

and then I run it and always I have the same error.

[Yvan Fournier]

Hello,

Did you check the files mentioned in the error message (which are also mentioned in the forum recommendations) ?

Regards,

Yvan