Hi, everyone
when I use the model of heavy fuel oil combustion, the results was not right. The temperature was significantly smaller than the expected?
The fuel was kerosene. The boundary "Inflow" was pure air, and "fuel" is pure kerosene.
The "dp_FUE" and "cs_user_boundary_conditions-fuel.f90" were below. Was it right?
Thank you very much!
Yuan huang
Problem of heavy fuel oil combustion in 4.0.3
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
Problem of heavy fuel oil combustion in 4.0.3
- Attachments
-
- src.zip
- (3.97 KiB) Downloaded 420 times
-
Yvan Fournier
- Posts: 4208
- Joined: Mon Feb 20, 2012 3:25 pm
Re: Problem of heavy fuel oil combustion in 4.0.3
Hello,
Without the other recommended information, it is hard to determine what is wrong.
Also, fuel combustion has been unused outside the scope of validation for a while, so I would not be surprised it there are bugs, but the provided info is not enough to tell if the issue is due to a bug or your setup.
Regards,
Yvan
Without the other recommended information, it is hard to determine what is wrong.
Also, fuel combustion has been unused outside the scope of validation for a while, so I would not be surprised it there are bugs, but the provided info is not enough to tell if the issue is due to a bug or your setup.
Regards,
Yvan