Page 1 of 1
Problem of verifying the quality of the mesh in CS 5.0
Posted: Fri Jun 23, 2017 3:35 pm
by sante
hello,
Since I installed the new version of code_saturne(C_S-5.0). I can not verify my mesh in the GUI.
"Please i need help"
Best regards
Sante Junior.
Re: Problem of verifying the quality of the mesh in CS 5.0
Posted: Fri Jun 23, 2017 4:12 pm
by Luciano Garelli
Hello,
In CS 5 you have to switch to the "prepocessing mode" (in the fig that you post you are in the "calculation mode") and then select "mesh quality criteria" in the preprocessing type.
Regards,
Luciano
Re: Problem of verifying the quality of the mesh in CS 5.0
Posted: Sat Jun 24, 2017 3:53 pm
by sante
Hello Luciano;
Thank you for your reply. Now I face another problem; When I want to load the boundary conditions I am asked for the file "check_mesh.log" which is absent. I do not know how to solve this new problem. Especially that I want to run a tutorial on burning pulverized coal with a Lagrangian approach.
Please, I still need your help
Regards
Sante Junior.
Re: Problem of verifying the quality of the mesh in CS 5.0
Posted: Sat Jun 24, 2017 4:03 pm
by sante
Hello,
Here is the mesh file of the tutriel in question.
Regards.
Sante Junior
Re: Problem of verifying the quality of the mesh in CS 5.0
Posted: Sun Jun 25, 2017 3:32 pm
by Luciano Garelli
Hello,
The file that you have to read in order to load the BC's is the preprocessor.log as the pop-up notifications says.
Regards,
Luciano
Re: Problem of verifying the quality of the mesh in CS 5.0
Posted: Tue Jun 27, 2017 9:25 pm
by sante
Hello Luciano,
Thanks you!!!!
Best Grgards
Sante Junior