Re: Does subroutine overwrite correctly?
Posted: Mon Feb 01, 2021 10:24 pm
Hello Yvan,
As I said last post, simulation never started when I use tetra mesh.
Yvan, do you think it is only due to mesh quality or something other parameters?
I understand hexa and tetra are better for simulation, but generally tetra also provides acceptable solution.
Actually, I have to run simulation by tetra mesh because of my own postprocessing.
Also as I said, simulation can be done if I set velocity value at inlet (it means non-pressure drive flow).
Therefore, we can run pressure drive flow even with tetra mesh.
Let me post error message and something. Would you Yvan and someone give me tips?
Best regards,
Tsubasa
As I said last post, simulation never started when I use tetra mesh.
Yvan, do you think it is only due to mesh quality or something other parameters?
I understand hexa and tetra are better for simulation, but generally tetra also provides acceptable solution.
Actually, I have to run simulation by tetra mesh because of my own postprocessing.
Also as I said, simulation can be done if I set velocity value at inlet (it means non-pressure drive flow).
Therefore, we can run pressure drive flow even with tetra mesh.
Let me post error message and something. Would you Yvan and someone give me tips?
Best regards,
Tsubasa