Hello everyone,
Hope you are doing well.
I found that in code_saturne GUI there is no far-field boundary condition choice. But I need that in simulation of a wind turbine. Is it possible to achieve that in code Saturne? Thank you.
Yan.
farfield boundary conditon
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
Yvan Fournier
- Posts: 4208
- Joined: Mon Feb 20, 2012 3:25 pm
Re: farfield boundary conditon
Hello,
You can define an inlet (possibly with a given profile) upstream of the turbine, and use symmetry (or free -inlet-outlet conditions) on the sides, with an outlet (or free inlet-outlet) downstream.
We do not have any specific "far-field" boundary type.
Regards,
Yvan
You can define an inlet (possibly with a given profile) upstream of the turbine, and use symmetry (or free -inlet-outlet conditions) on the sides, with an outlet (or free inlet-outlet) downstream.
We do not have any specific "far-field" boundary type.
Regards,
Yvan
Re: farfield boundary conditon
Hi Yvan,Yvan Fournier wrote:Hello,
You can define an inlet (possibly with a given profile) upstream of the turbine, and use symmetry (or free -inlet-outlet conditions) on the sides, with an outlet (or free inlet-outlet) downstream.
We do not have any specific "far-field" boundary type.
Regards,
Yvan
Thank you. I have ran the case as you said. I think it works well.
Yan.