Roughness height in uscpl.f90 file.
Posted: Thu Jan 06, 2011 6:17 pm
Dear Support and Users
I'm trying to set wall BC as rough solid face in uscpl file (coal combustion) with roughness height 1cm:
Unfortunately I receive the following error:
As far as I'm concerned it arises from incoherency between velocity and some scalars. Should I add specific conditions for scalars when using iparug BC?
Thank you in advance
Norbert
I'm trying to set wall BC as rough solid face in uscpl file (coal combustion) with roughness height 1cm:
Code: Select all
CALL GETFBR('wall',NLELT,LSTELT)
!==========
do ilelt = 1, nlelt
ifac = lstelt(ilelt)
! Kind of boundary conditions for standard variables
itypfb(ifac,iphas) = iparug
rcodcl(ifac, iu(iphas), 3) = 0.01d0
! zone's number (from 1 to n) izone = 5
! - Allocation of the zone's number to the face
izfppp(ifac) = izone
enddoUnfortunately I receive the following error:
@
@@ WARNING: ABORT DURING THE BOUNDARY CONDITIONS VERIF.
@ ========
@
@ Uninitialized boundary conditions : 0
@ Unexpected boundary conditions:
@ on the scalars : 0
@ on the scalars representing
@ a variance : 0
@ Incoherencies:
@ between velocity and scalars : 240
@
@ The calculation will not be run.
@
@ Verify the parameters given via the interface or
@ usclim.
@
Call stack:
1: 0x7f8bb9d6a844 <vericl_+0x5d94> (libsaturne.so.0)
2: 0x7f8bb9b852a2 <condli_+0x15c2> (libsaturne.so.0)
3: 0x7f8bb9d3c821 <tridim_+0x6931> (libsaturne.so.0)
4: 0x7f8bb9b74855 <caltri_+0x5085> (libsaturne.so.0)
5: 0x7f8bb9b4fc63 <cs_run+0x8a3> (libsaturne.so.0)
6: 0x7f8bb9b4ff45 <main+0x1f5> (libsaturne.so.0)
7: 0x7f8bb6b80abd <__libc_start_main+0xfd> (libc.so.6)
8: 0x402c69 ? (?)
End of stack
As far as I'm concerned it arises from incoherency between velocity and some scalars. Should I add specific conditions for scalars when using iparug BC?
Thank you in advance
Norbert