code_saturne User's Forum

Posted: **Mon Feb 21, 2011 7:31 pm**

Hello, I have a problem with Saturne 1.3.3. If I try to run a simulation using a mesh with approximately 10,000 or more nodes I get the following error. ERREUR WHILE RUNNING THE KERNEL (SOLVER) and the program stops. However if I take the exact same mesh file and run the simulation using Saturne 2.0 there is no problem. I really have no idea what could be causing this. Any advice would be appreciated.

Kindly let me know.

Regards,

Debashis Basu

Posted: **Mon Feb 21, 2011 9:50 pm**

The error implies the preprocessor is fine... you probably need to increase the array size, what's the lisiting say?

code_saturne User's Forum

Problem with pre-processor

Problem with pre-processor

Re: Problem with pre-processor