Use the compressible module: how to?
Posted: Thu Oct 07, 2010 3:34 pm
Hi
Going from a standard incompressible calculation, i would like to know how to go to a compressible one.
Following the manual, i added a few files in the SRC folder, modified the files according to the examples (for boundary conditions and so on).
But i'm really not sure i'm doing it right, being more used to "point and click" softwares with automated templates to go from one mode to another.
With the attached file, i want to set a 67m/s incoming flow velocity on "Flow-Bd-1", wall for "Walls".
Temperature is 20degrees
Is here a specific tutorial for the compressible module ?
Going from a standard incompressible calculation, i would like to know how to go to a compressible one.
Following the manual, i added a few files in the SRC folder, modified the files according to the examples (for boundary conditions and so on).
But i'm really not sure i'm doing it right, being more used to "point and click" softwares with automated templates to go from one mode to another.
With the attached file, i want to set a 67m/s incoming flow velocity on "Flow-Bd-1", wall for "Walls".
Temperature is 20degrees
Is here a specific tutorial for the compressible module ?