How to set the value of pressure at the boundary of outlet?
Posted: Wed May 16, 2012 1:28 pm
Hi, everyone
How to set the value of pressure at the boundary of outlet in usclim?
In the standard boundary "Free outlet", the pressure is always handled as a Dirichlet condition.
Can it be handled in the "non-standard" boundary ? How to do this?
And how to set the massflow rate in the boundary of Inlet?
Thanks very much!
Yuan Huang
How to set the value of pressure at the boundary of outlet in usclim?
In the standard boundary "Free outlet", the pressure is always handled as a Dirichlet condition.
Can it be handled in the "non-standard" boundary ? How to do this?
And how to set the massflow rate in the boundary of Inlet?
Thanks very much!
Yuan Huang