mesh_output file not created
Posted: Wed Sep 04, 2024 11:46 am
Hello,
I would like to use a mesh deformed by a previous simulation, as input for a new one.
However, I cannot manage to get the mesh_output file (at the end of the deformable mesh simulation) created inside the checkpoint directory.
I have ticked "Save mesh if modified by preprocessing" (even if not sure it applies since the deformation is done by the calculation), and I activated "Transient coordinates" in Time-dependency in the writer.
Any suggestion about possible mistakes I may do?
Thank you very much in advance.
Kind regards,
Daniele
I would like to use a mesh deformed by a previous simulation, as input for a new one.
However, I cannot manage to get the mesh_output file (at the end of the deformable mesh simulation) created inside the checkpoint directory.
I have ticked "Save mesh if modified by preprocessing" (even if not sure it applies since the deformation is done by the calculation), and I activated "Transient coordinates" in Time-dependency in the writer.
Any suggestion about possible mistakes I may do?
Thank you very much in advance.
Kind regards,
Daniele