Code: Select all
Start reading
Reading dimensions complete
Reading the previous time step number (restarting computation) NTPABS = 500
Reading the previous time step number (restarting computation) TTPABS = 0.5000E+02
Reading options complete
Read variables from restart: restart/main.csc
Reading complete
READING THE AUXILIARY RESTART FILE
Start reading
Finished reading options
restart/auxiliary.csc: section "ref_presstot01" not present.
@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@
@ @@ WARNING: WHEN READING THE AUXILIARY RESTART FILE
@ =======
@ Lecture des proprietes physiques
@
@ It was not possible to read some values from the
@ auxiliary restart file.
@ They will be initialized by the default values.
@
@ This situation can occur when the restart file
@ originates from a run realised with different
@ options or when the file is damaged.
@
@ The run will continue...
@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@
Fin de la lecture des proprietes physiques
Fin de la lecture du pas de temps
Fin de la lecture des flux de masse
Fin de la lecture des conditions aux limites
restart/auxiliary.csc: section "time_moments:sizes" not present.
Fin de la lecture des donnees ALE
@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@
@ @@ WARNING: WHEN READING THE AUXILIARY RESTART FILE
@ =======
@
@ The max number of structures NBMOMX supported by
@ the writing format of the suite file is
@ NFMTST = 99
@ There is here a greater number of structures
@ NSTRMX = 200
@ If the effective number of structures is greater,
@ these will not be reread.
@
@ The run will continue.
@
@ Check the subroutine lecamx.
@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@
Fin de la lecture des donnees des structures ALE
End reading
I already tried changing the I/O writing and reading modes, and deactivated the parallel I/O too. Can anybody help me out ?. My mesh doesnt move at all.
Thanks by advance,
Here are some of my files :