Code_Saturne Syrthes coupling with heavy meshes
Posted: Fri Mar 27, 2020 9:25 am
Hi,
I've been using Code-Saturne (v3.0.5) and Syrthes (v 4.1.1) for 4-5years for my work (hvac simulations), and I often encounter the same problem when using heavy meshes.
The matter is, when I run coupled simulations, the calculation starts, and stops at mesh structure and coupling computation (process are still running, but calculation never goes on to next stage).
This bug occurs one or twice for each calculation realised, and until now I solved it simply by killing/running again the simulation, without any change, until it finally goes to first iteration.
The matter is, I'm currently trying to run a new coupled case, and I already tried to kill/run it many times without success.
Code_Saturne and Syrthes calculations work fine separatly.
May the problem come from my installation?
Here are the files I'm using (except meshes who are too large)
Best regards,
Fanny
I've been using Code-Saturne (v3.0.5) and Syrthes (v 4.1.1) for 4-5years for my work (hvac simulations), and I often encounter the same problem when using heavy meshes.
The matter is, when I run coupled simulations, the calculation starts, and stops at mesh structure and coupling computation (process are still running, but calculation never goes on to next stage).
This bug occurs one or twice for each calculation realised, and until now I solved it simply by killing/running again the simulation, without any change, until it finally goes to first iteration.
The matter is, I'm currently trying to run a new coupled case, and I already tried to kill/run it many times without success.
Code_Saturne and Syrthes calculations work fine separatly.
May the problem come from my installation?
Here are the files I'm using (except meshes who are too large)
Best regards,
Fanny