problems with boundary conditions
Posted: Thu Mar 28, 2019 7:59 pm
hi,
I'm working on a simulation of an air flow on a sphere inside a wind tunnel but I am having some problems at the time of the simulation.
the error message is
First face with boundary condition definition error
(out of 15000)
has boundary condition type 0, center (0.475, 0.1485, 0.00155)
cs_boundary_conditions.c:363: Fatal error.
create groups on faces, these groups are: inlet outlet, walls and simetry
thank you very much, greetings from chile.
I'm working on a simulation of an air flow on a sphere inside a wind tunnel but I am having some problems at the time of the simulation.
the error message is
First face with boundary condition definition error
(out of 15000)
has boundary condition type 0, center (0.475, 0.1485, 0.00155)
cs_boundary_conditions.c:363: Fatal error.
create groups on faces, these groups are: inlet outlet, walls and simetry
thank you very much, greetings from chile.