Page 1 of 1
farfield boundary conditon
Posted: Mon Aug 07, 2017 3:21 pm
by yany
Hello everyone,
Hope you are doing well.
I found that in code_saturne GUI there is no far-field boundary condition choice. But I need that in simulation of a wind turbine. Is it possible to achieve that in code Saturne? Thank you.
Yan.
Re: farfield boundary conditon
Posted: Mon Aug 07, 2017 11:32 pm
by Yvan Fournier
Hello,
You can define an inlet (possibly with a given profile) upstream of the turbine, and use symmetry (or free -inlet-outlet conditions) on the sides, with an outlet (or free inlet-outlet) downstream.
We do not have any specific "far-field" boundary type.
Regards,
Yvan
Re: farfield boundary conditon
Posted: Tue Aug 08, 2017 11:18 am
by yany
Yvan Fournier wrote:Hello,
You can define an inlet (possibly with a given profile) upstream of the turbine, and use symmetry (or free -inlet-outlet conditions) on the sides, with an outlet (or free inlet-outlet) downstream.
We do not have any specific "far-field" boundary type.
Regards,
Yvan
Hi Yvan,
Thank you. I have ran the case as you said. I think it works well.
Yan.