code_saturne User's Forum

Hi all:

I have a simple question about ParaView. If my geometry is very long, when I look into the temperature distribution, I want to scale down by 10 only in the z direction, how can I do that? Thanks a lot!

Best Regards!
Jundi He

Hello,

I think that you want to scale the geometry in the "z" direction. You can use the filter "Transform" for that.
http://www.paraview.org/Wiki/ParaView/U ... #Transform

Regards

Luciano

Luciano:

Thank you so much, I can make the result more clear by scaling down the axial direction.

Best Regards!
Jundi He