Hi all:
I have a simple question about ParaView. If my geometry is very long, when I look into the temperature distribution, I want to scale down by 10 only in the z direction, how can I do that? Thanks a lot!
Best Regards!
Jundi He
Quick question about Paraview
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
- Posts: 284
- Joined: Fri Dec 04, 2015 1:42 pm
Re: Quick question about Paraview
Hello,
I think that you want to scale the geometry in the "z" direction. You can use the filter "Transform" for that.
http://www.paraview.org/Wiki/ParaView/U ... #Transform
Regards
Luciano
I think that you want to scale the geometry in the "z" direction. You can use the filter "Transform" for that.
http://www.paraview.org/Wiki/ParaView/U ... #Transform
Regards
Luciano
Re: Quick question about Paraview
Luciano:
Thank you so much, I can make the result more clear by scaling down the axial direction.
Best Regards!
Jundi He
Thank you so much, I can make the result more clear by scaling down the axial direction.
Best Regards!
Jundi He