code_saturne User's Forum

Hi

I am using v4. I am wondering if there's a way to get the temperature at the boundary for the postprocessing. I found in the cs_user_parameters.f90 there is a line mentioning about the post_boundary_temperature at the section of tstar and tplus field but I couldn't find any more information in the doxygen. Could anyone guide me on how to start?

Cheers.

Hello,

I think you can activate it directly from the GUI

There may be missing examples under Doxygen...

Regards,

Yvan

Hi Yvan,

Thank you again for your reply.
I am right now using nonGUI approach.
I wonder how to specified it within subroutines for this temperature at the boundary if I could.



Muhsin

Hello,

I really recommend the GUI for this.

Using the forum from my phone, not logged on to my computer, I'm not sure where you may find the doc, as this is a specific option (we have a more general appeoach in 4.3). There might be an example in cs_user_parameters-output.f90 in the examples, but I'm not sure. There might also be a mention in rhe user doc pdf, but I'm not sure either.

Regards,

Yvan