Page 1 of 1
GUI setup of a turbomachinery model
Posted: Fri May 22, 2015 3:02 am
by ffan
Dear Code_Saturne users and developers,
Code_Saturne version 4.0 has turbomachinary model available in GUI. It would be really nice to have an example of GUI setup of a complete turbomachinary model. Thanks.
- ffan
Re: GUI setup of a turbomachinery model
Posted: Sat May 23, 2015 12:03 am
by Yvan Fournier
Hello,
I encourage other users to also contribute examples.
I'll be off-line most of next week, but when I return, I'll try to remember to check with others whether we should add an "examples" section in the forum (as we had in its old incarnation).
In the meantime, I'll post two xml files from our verification test suite. You can adapt it to your case.
Regards,
Yvan
Re: GUI setup of a turbomachinery model
Posted: Sun May 24, 2015 6:10 pm
by ffan
Thank you Yvon. If Code_Saturne can publish its test cases, they would be very helpful as examples. (Code_Aster publishes its test cases for people to use as examples.)
- ffan
Re: GUI setup of a turbomachinery model
Posted: Wed May 27, 2015 5:54 pm
by Yvan Fournier
Hello,
Yes, I agree, but we still need to sort out which subset of the test case can be published (most cases are not confidential, but there is quite a bit of experimental data which we are not free to publish, and as the validation base is regularly updated, we need to work on automated extraction of the publishable part)...
Regards,
Yvan
Re: GUI setup of a turbomachinery model
Posted: Wed May 27, 2015 6:02 pm
by ffan
Yes, there are some test cases in Code_Aster that are blocked out also.
- ffan