Result of calculation as a BC for another calculation
Posted: Wed Jan 16, 2013 4:11 pm
Hi all,
i'm doing several simulations with mrf algorithm in steady state. I would like to do such a thing: at the end of a mrf simulation i can see at the boundary coupled condition the velocities for each cell. I would like to start again another simulation, not coupled, with only the stator ( so without the rotor part) where at the boundary where previously was coupled the mrf now i impose the velocities calculated before. Doing so i can reduce the calculation effort of the mrf and start to calculate in transient with only one fluid volume not coupled.
Any idea? Thanks
Andrea
i'm doing several simulations with mrf algorithm in steady state. I would like to do such a thing: at the end of a mrf simulation i can see at the boundary coupled condition the velocities for each cell. I would like to start again another simulation, not coupled, with only the stator ( so without the rotor part) where at the boundary where previously was coupled the mrf now i impose the velocities calculated before. Doing so i can reduce the calculation effort of the mrf and start to calculate in transient with only one fluid volume not coupled.
Any idea? Thanks
Andrea