[Running Problem] "not seem to be inside a case directory"

[m_f]

Hello,

After following tutorials about Code_Saturne installation, I decided to try a very simple case : a block into a flow. Very easy case. So, after opening termina, I start Code_Saturne.GUI and It works perfectly.
But, when I decided to start resolution, this message appears :

Code: Select all

Error:
/usr/local/bin/code_saturne run --param data
run from directory "/home/Public/studyname",
which does not seem to be inside a case directory.

This error appeared even if the software found all data alone, as MESH,or folders, in "Identify PATH" part, at the beginning of the software. I don't understand what's wrong.

Have a good day,
Best regards,

m_f

[Yvan Fournier]

Hello,

What version are you using ? I believe this is fixed in recent versions, but I need to check.

In any case, just run the GUI from the case directory (one level lower than the study directory), and you should be fine.

Regards,

Yvan

[m_f]

Hello,

What version are you using ? I believe this is fixed in recent versions, but I need to check.

In any case, just run the GUI from the case directory (one level lower than the study directory), and you should be fine.

Regards,

Yvan

I'll verify tomorrow that I runned from the case directory, I'm not sure.
It's the 2.2.2 version of Code_Saturne.

Good evening,
Regards

m_f

[m_f]

It doesn't work, even if I run from the /home/public from a terminal...same error :

Code: Select all

/usr/local/bin/code_saturne run --param data
run from directory "/home/Public/",
which does not seem to be inside a case directory.

Regards,
m_f

[Yvan Fournier]

Hello,

You did not follow my instructions regarding the directory from which to run the code...

Regards,

Yvan

[m_f]

Hello,

You did not follow my instructions regarding the directory from which to run the code...

Oh, I'm confused. I mixed up "upper" and "lower". It seems work better.
Sorry for this stupid mistake...

Have a good day,
m_f