Re: Sub-routine calling rasize: MEMLA2
Posted: Mon Oct 08, 2012 9:57 pm
Hello Mathieu,
In these weeks I tried changing parameters in GUI and finally I solved "acos". After that I had an other issue on output but I understood my error: I used a time step too much long for hig velocity fluid flow through my small nozzle. A bit silly!
Now I can show off particles tracking and trajectories very well. I'm writing my thesis and my tutor congratulates me, so I want to thank you and Yvan for your time and your assistance.
When I'm improving my work or undertake different experiences using CS, if I need some helps I'll try with a post here.
Always thankful,
Fabio
In these weeks I tried changing parameters in GUI and finally I solved "acos". After that I had an other issue on output but I understood my error: I used a time step too much long for hig velocity fluid flow through my small nozzle. A bit silly!
Now I can show off particles tracking and trajectories very well. I'm writing my thesis and my tutor congratulates me, so I want to thank you and Yvan for your time and your assistance.
When I'm improving my work or undertake different experiences using CS, if I need some helps I'll try with a post here.
Always thankful,
Fabio