Dear forums
i am trying to work on the internal coupling analysis for a pouch model (Tooth paste dispenser)
the thickness of the pouch is 12mm and if i start the run with the ALE internal coupling approach the displacement obtained for 2000 iterations is just 2.47e-06 (higher stiffness) nothing but 0.0002mm which is very much low.
my main criteria is calculate the time taken to dispense the volume of 13ml from the pouch with a mass flow rate of 0.002 kg/s with deformation
so please help me out
with regards
theja
Internal coupling in ALE
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
Re: Internal coupling in ALE
A thickness of 12mm? Even if you wanted to put 1.2mm, are you sure about that value? Looks a bit too thick even for a soft flexible material.
Other than that, I would check the system of units used, it's quite common to mix Pascals and Kgf/cm^2 and things alike. Always use SI.
Other than that, I would check the system of units used, it's quite common to mix Pascals and Kgf/cm^2 and things alike. Always use SI.