Dear all,
I'm currently performing some runs with gas combustion and I'm trying to find some tips and tricks in order to have a flame countour, but I don't know exactly how to do this.
Would someone have an idea? Looking at contours of YM_FUEL (I guess it is a mass fraction and not a volumic fraction) at LFL is the only solution I am
currently thinking about...
Best regards and thank you in advance for your feedback.
Julien
Flame visualization when using gas combustion
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
Re: Flame visualization when using gas combustion
Hello,
You can make an isocontour of a low epsilon of Var_FrMe. Otherwise an isocontour or isovolume of temperature should be ok also.
And YM_fuel is a mass fraction of course. It's a mistake in the code.
Mickaël
You can make an isocontour of a low epsilon of Var_FrMe. Otherwise an isocontour or isovolume of temperature should be ok also.
And YM_fuel is a mass fraction of course. It's a mistake in the code.
Mickaël