Reading of chemistry profiles file

[sophie Lu]

Dear all,

I am doing the simulation about gas chemistry for in CS9.0. When I run the model, meteo file can be read normally, but chemistry profiles file data only can be read in the third hours .

However, before when I run this case in CS8.2, all the hourly data of chemistry profile can be read. I have checked referenced source files, they are basically same. Is that any difference between this two versions or any options I need to be added in the cs_user_parameter?

I have attached my run_solver.log and chemistry file.

Thanks,
Sophie

[Yvan Fournier]

Hello,

I am not aware of any voluntary change in the settings. So this may be a bug. Could you post a setup.xml file so we can compare the behavior between versions here an check this ?

Best regards,

Yvan

[sophie Lu]

Hi Yvan,
please see the attached cs_user_parameters.c and setup.xml.

Thanks!
Sophie

[Yvan Fournier]

Hello,

The code complains it is missing some spack file. Coul you post species.spack.dat ?

Regards,

Yvan