How to smooth threshold data in Paraview

Questions and remarks about code_saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
roberto.bernetti
Posts: 35
Joined: Tue Apr 16, 2019 10:03 pm

How to smooth threshold data in Paraview

Post by roberto.bernetti »

I dont know if this is the right place to post this question.
I would have some hint on how to smoth plot data relevant to the transported scalar by the threshold filter
POraThreshold.PNG
Last edited by roberto.bernetti on Fri May 24, 2019 9:28 am, edited 1 time in total.
Saluti
Roberto
mstorti
Posts: 4
Joined: Wed Jan 25, 2017 2:00 pm

Re: How to smoth threshold data in Paraview

Post by mstorti »

Perhaps you should include a "Cell Data to Point Data" filter before the threshold?
roberto.bernetti
Posts: 35
Joined: Tue Apr 16, 2019 10:03 pm

Re: How to smooth threshold data in Paraview

Post by roberto.bernetti »

mstorti wrote: Tue May 21, 2019 2:09 pm Perhaps you should include a "Cell Data to Point Data" filter before the threshold?
I tryed with no different results. After the Threshold filter has been selected the Cell Data to Point Data can be no more selected.
Last edited by roberto.bernetti on Fri May 24, 2019 9:28 am, edited 1 time in total.
Saluti
Roberto
mstorti
Posts: 4
Joined: Wed Jan 25, 2017 2:00 pm

Re: How to smoth threshold data in Paraview

Post by mstorti »

Sorry, I was wrong. The Threshold filter selects the set of cells whose values are in the given range, and the result is intrinsically a staircased surface.

Perhaps you want to use a Contour filter instead? In that case you do need a Cell Data to Point Data filter.
Post Reply