hi,
I'm working on a simulation of an air flow on a sphere inside a wind tunnel but I am having some problems at the time of the simulation.
the error message is
First face with boundary condition definition error
(out of 15000)
has boundary condition type 0, center (0.475, 0.1485, 0.00155)
cs_boundary_conditions.c:363: Fatal error.
create groups on faces, these groups are: inlet outlet, walls and simetry
thank you very much, greetings from chile.
problems with boundary conditions
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
- Posts: 4085
- Joined: Mon Feb 20, 2012 3:25 pm
Re: problems with boundary conditions
Hello,
Did you use the error postprocessing visualization to see which faces cause issues ?
The forum usage recommendations provide a more detailed list of information which can be useful to help solve the issue.
Regards,
Yvan
Did you use the error postprocessing visualization to see which faces cause issues ?
The forum usage recommendations provide a more detailed list of information which can be useful to help solve the issue.
Regards,
Yvan