Imposed velocity ALE

Miscellaneous discussion topics about Code_Saturne (development, ...)
Post Reply
jcharris
Posts: 3
Joined: Tue Apr 16, 2019 7:28 pm

Imposed velocity ALE

Post by jcharris » Fri Apr 19, 2019 2:21 pm

Just as a comment... Would it be possible in future versions to have access to x/y/z when setting the mesh velocity by the GUI with the mathematical expression editor, as it is already for setting the fluid velocity at an inlet? This could simplify the setup of a few interesting problems.

Yvan Fournier
Posts: 2638
Joined: Mon Feb 20, 2012 3:25 pm

Re: Imposed velocity ALE

Post by Yvan Fournier » Wed May 01, 2019 4:11 pm

Hello,

Yes, this should be possible once we finish replacing the MEI (Mathematical Expression Interpreter) functions with its MEG (Mathematical Expression Generator) equivalents (done almost everywhere, ALE BC's still missing...).

Best regards,

Yvan

Post Reply