Imposed velocity ALE
Imposed velocity ALE
Just as a comment... Would it be possible in future versions to have access to x/y/z when setting the mesh velocity by the GUI with the mathematical expression editor, as it is already for setting the fluid velocity at an inlet? This could simplify the setup of a few interesting problems.

 Posts: 2638
 Joined: Mon Feb 20, 2012 3:25 pm
Re: Imposed velocity ALE
Hello,
Yes, this should be possible once we finish replacing the MEI (Mathematical Expression Interpreter) functions with its MEG (Mathematical Expression Generator) equivalents (done almost everywhere, ALE BC's still missing...).
Best regards,
Yvan
Yes, this should be possible once we finish replacing the MEI (Mathematical Expression Interpreter) functions with its MEG (Mathematical Expression Generator) equivalents (done almost everywhere, ALE BC's still missing...).
Best regards,
Yvan