Page 1 of 1

Generating "configure" file for the trunk version

Posted: Fri May 31, 2019 1:53 am
by ffan
Hi CS users,

I downloaded the trunk version. Since no "configure" file was found, I ran automake. There were errors (attached). Please help. Thanks.

- ffan

Re: Generating "configure" file for the trunk version

Posted: Fri May 31, 2019 9:11 am
by Yvan Fournier
Hello,

This is not sufficient. The procedure is described in the installation documentation (pdf). I'll try to remember to add it to the README.md file also.

You simply need to run ./sbin/bootstrap in the sources folder (it includes calls to automake, but not just that).

Regards,

Yvan

Re: Generating "configure" file for the trunk version

Posted: Sat Jun 01, 2019 3:43 am
by ffan
It works. Thanks.

- ffan