Issues to coupling with SALOME-MECA 2018
Posted: Thu Apr 25, 2019 3:21 pm
Dear,
I already have Salome-Meca 2018 installed on my PC. So that I don't have to install SALOME again (via Salome-Plataform or Salome-CFD), I would just like to couple the Code-Saturne (CFDSTUDY) package to Salome-Meca.
However, I'm not able to couple the packages.
I tried the two installation modes:
1) install_saturne.py -> setup (with installation ID with salome and path "/home/erick/salome_meca/V2018.0.1_public").
2) configure (also with the same folder ID with salome above) -> make -> make install.
The logs for case 1 is below. For case 2, after run "make install" it seems that nothing occurs, no logs or errors messages. Then I run Salome-Meca and CFDSTUDY isn't there.
I don't found anything about this error or make install trouble.
If you can help me, I will be immensely grateful.
The computer is a Dell XPS 15, NVIDIA video card, Ubuntu 18.04 LTS.
Thanks,
Erick.
I already have Salome-Meca 2018 installed on my PC. So that I don't have to install SALOME again (via Salome-Plataform or Salome-CFD), I would just like to couple the Code-Saturne (CFDSTUDY) package to Salome-Meca.
However, I'm not able to couple the packages.
I tried the two installation modes:
1) install_saturne.py -> setup (with installation ID with salome and path "/home/erick/salome_meca/V2018.0.1_public").
2) configure (also with the same folder ID with salome above) -> make -> make install.
The logs for case 1 is below. For case 2, after run "make install" it seems that nothing occurs, no logs or errors messages. Then I run Salome-Meca and CFDSTUDY isn't there.
I don't found anything about this error or make install trouble.
If you can help me, I will be immensely grateful.
The computer is a Dell XPS 15, NVIDIA video card, Ubuntu 18.04 LTS.
Thanks,
Erick.