Page 1 of 2
SYRTHES 4.3 with CS 3.0.7
Posted: Fri Jun 03, 2016 10:41 am
by andrea28
Hi,
I have Code Saturne 3.0.7 installed on Red Hat Linux, which version of Syrthes do you suggest to install?
Thanks for the attention
Andrea
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Sun Jun 05, 2016 1:44 pm
by Yvan Fournier
Hello,
If I remember correctly, a change in the coupling protocol was done between CS 3 and 4, leading to the Syrthes 4.2/4.2 differences (i.e. Syrthes 4.2 and 4.2 were almost identical, with Syrthes 4.2 compatible with Code_Saturne 3.0, and Syrthes 4.2 compatible with Code_Saturne 4.x...
So Syrthes 4.2 would be the recommended version.
Regards,
Yvan
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Mon Jun 06, 2016 9:23 am
by andrea28
Thanks!!!
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Wed Jun 15, 2016 7:43 am
by andrea28
Yvan Fournier wrote:
So Syrthes 4.2 would be the recommended version.
Regards,
Yvan
Sorry, do you know where i can find this version? because on the Syrthes site I get only version 4.3 and 4.1.1 .
Thank you.
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Wed Jun 15, 2016 11:20 am
by Yvan Fournier
Hello,
Sorry, I throught there was an "official" public version 4.2. As this seems not to be the case, for Code_Saturne version 3.0, you can use Syrthes 4.1.1 instead (version 4.2 will not be compatible)
Best regards,
Yvan
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Thu Jun 16, 2016 10:23 am
by andrea28
Hi Yvan,
thanks for the reply, I am having this error during the installation: ple_config.h: No such file or directory.
Do you have any suggestion? I have attached the setup file and the error file.
Regards
Andrea
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Mon Jun 20, 2016 5:25 pm
by Yvan Fournier
Hello,
Your path to libple in the setup.ini seems to be the path to the ple directory in the Code_Saturne sources, but the path you need is the one of the Code_Saturne install..
Regards,
Yvan
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Fri Jul 01, 2016 10:12 am
by andrea28
Thanks for the help,
I finally install Syrthes without errors, but now when I try to source it I get
SYRTHES4_HOME=...path to the architecture... Command not found.
NOM_ARCH=... Command not found.
LD_LIBRARY_PATH= ... Command not found.
SYRTHES4_MPIPATH= ... Command not found.
SYRTHES4_HOME: Undefined variable.
Thanks for the attention.
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Fri Jul 01, 2016 4:43 pm
by Yvan Fournier
Hello,
Which command do you use to source it ?
Regards,
Yvan
Re: SYRTHES 4.3 with CS 3.0.7
Posted: Tue Jul 05, 2016 10:02 am
by andrea28
Hello,
I used both
source ../bin/syrthes.profile
../bin/syrthes.profile
Regards
Andrea