Boundary condition from Salome to Saturne

Questions and remarks about code_saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
Jonathan Gerardin

Boundary condition from Salome to Saturne

Post by Jonathan Gerardin »

Hello,
 
I've got a problem with my boundaries condition and I don't know if my problem is in Salome or in Saturne.
 
In Salome :
I've create a simple box. I meshed it with hexahedrons. I created groups of mesh_1 to obtain 6 groups (1 for each face) named face_1 ... When I select those face (which are in Groups of Faces under Mesh_1), I can see the corresponding mesh face. i export the mesh_1.UNV .
 
In Saturne :
 
In the Boundary condition menu -> Definition of boundary regions, I add 6 boundaries conditions.
What have I supposed to put in Label, Zone and Selection criteria? in Label, I put face_1 ... like the label in Salome, but in Zone et Selection criteria?? (in zone, there is number 1 to 6 and in selection criteria, it's all[])
 
I've got some error of zone already marked with a zone number.
 
Can somebody explain to me the error and if my mesh is good?
 
Thank you
 
Jonathan GERARDIN
 
Claus Andersen

Re: Boundary condition from Salome to Saturne

Post by Claus Andersen »

I had the same problem a while back - it is explained here. Short version is to put you group names in 'selection criteria' :)
https://code-saturne.info/products/code-saturne/forums/general-usage/906800145#745337610
Jonathan Gerardin

Re: Boundary condition from Salome to Saturne

Post by Jonathan Gerardin »

thank you! It works!
Post Reply