Hello,
I would like to know how to impose free slip boundary condition for a wall.
Is it possbile to do that with GUI setting?
Best regards,
Tsubasa
Free slip boundary condition
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
Yvan Fournier
- Posts: 3903
- Joined: Mon Feb 20, 2012 3:25 pm
Re: Free slip boundary condition
Helllo,
Using a symmetry condition should be the equivalent to this. It is available in the GUI.
Though using this assumes homogeneous Neumann conditions for all scalars.
If you need finer control to mix free slip and other BC's for scalars, that is not in the GUI.
Best regards,
Yvan
Using a symmetry condition should be the equivalent to this. It is available in the GUI.
Though using this assumes homogeneous Neumann conditions for all scalars.
If you need finer control to mix free slip and other BC's for scalars, that is not in the GUI.
Best regards,
Yvan