Hello,
is there any possibility to use internal surface for head loss definition instead of volume zone? This should represent for example thin perforated plate or filtration fabric.
Regards
Michal
Head loss on surface
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
- Posts: 4075
- Joined: Mon Feb 20, 2012 3:25 pm
Re: Head loss on surface
Hello,
No, I do not think it is possible with the current code. So the best solution is probably to apply the head loss to a thin layer of cells (which assumes your mesh provides for this).
Best regards,
Yvan
No, I do not think it is possible with the current code. So the best solution is probably to apply the head loss to a thin layer of cells (which assumes your mesh provides for this).
Best regards,
Yvan
Re: Head loss on surface
Yvan,
thank you for info. Perhaps in the feature it could be interesting part of code.
Regards
Michal
thank you for info. Perhaps in the feature it could be interesting part of code.
Regards
Michal