Dear all,
Please could you give me some advice on how to set the previous result as an initial value for a new simulation? I learned from previous post that it can be done through GUI, but I did't find how to achieve this.
I'm using Code_Saturne 6.0.5 through GUI now.
Many thanks and best regards,
Ruonan
How to set the previous result as an initial value for a new simulation?
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
- Posts: 4080
- Joined: Mon Feb 20, 2012 3:25 pm
Re: How to set the previous result as an initial value for a new simulation?
Hello,
This is available in the GUI under Time settings/Start-restart.
Regards,
Yvan
This is available in the GUI under Time settings/Start-restart.
Regards,
Yvan
Re: How to set the previous result as an initial value for a new simulation?
Hello Yvan,
Thank you very much for your reply. I succeed in doing this.
I found it is not difficult: first, in Time settings-Stopping criterion, specify an additional time steps; then, in Time settings-Start/Restart-Checkpoint/Restart, select a checkpoint from previous result file to restart.
Thank you again.
Best regards,
Ruonan
Thank you very much for your reply. I succeed in doing this.
I found it is not difficult: first, in Time settings-Stopping criterion, specify an additional time steps; then, in Time settings-Start/Restart-Checkpoint/Restart, select a checkpoint from previous result file to restart.
Thank you again.
Best regards,
Ruonan