Page 1 of 1
How to smooth threshold data in Paraview
Posted: Tue May 21, 2019 2:05 pm
by roberto.bernetti
I dont know if this is the right place to post this question.
I would have some hint on how to smoth plot data relevant to the transported scalar by the threshold filter
Re: How to smoth threshold data in Paraview
Posted: Tue May 21, 2019 2:09 pm
by mstorti
Perhaps you should include a "Cell Data to Point Data" filter before the threshold?
Re: How to smooth threshold data in Paraview
Posted: Tue May 21, 2019 2:53 pm
by roberto.bernetti
mstorti wrote: ↑Tue May 21, 2019 2:09 pm
Perhaps you should include a "
Cell Data to Point Data" filter before the threshold?
I tryed with no different results. After the Threshold filter has been selected the
Cell Data to Point Data can be no more selected.
Re: How to smoth threshold data in Paraview
Posted: Tue May 21, 2019 5:57 pm
by mstorti
Sorry, I was wrong. The Threshold filter selects the set of cells whose values are in the given range, and the result is intrinsically a staircased surface.
Perhaps you want to use a Contour filter instead? In that case you do need a Cell Data to Point Data filter.