### Boundary condition definition error

Posted:

**Thu May 16, 2019 10:45 am**Hi

I'm running a steady analysis on a box of water simulating the diffusivity of temperature and salinity.

At the inlet I imposed velocity of water and imposed values of temperature and salinity.

During the run I got the following error:

The center face coordinates seem to be on the inlet boundary, but I cant guess which type of condition is the "type 0"

In the preprocessor log appear a :
and 1300 is the difference between the surface elements of the boundary and the preprocessor stated bundary faces
Is there any relations?

I'm running a steady analysis on a box of water simulating the diffusivity of temperature and salinity.

At the inlet I imposed velocity of water and imposed values of temperature and salinity.

During the run I got the following error:

Code: Select all

```
First face with boundary condition definition error
(out of 1300)
has boundary condition type 0, center (7.98961, 50.0653, 4.75973)
../../../../src/code_saturne-5.0.9/src/base/cs_boundary_conditions.c:363: Fatal error.
Some boundary condition definitions are incomplete or incorrect.
For details, read the end of the calculation log,
or visualize the error postprocessing output.
```

In the preprocessor log appear a :

Code: Select all

```
Default family
(no group)
Number of internal faces : 1823196
Number of boundary faces : 1300
```

Code: Select all

```
Main mesh properties
--------------------
Number of cells: 934222
Number of internal faces: 1823196
Number of boundary faces: 90496
Number of vertices: 179897
```