Page 1 of 1

problems with boundary conditions

Posted: Thu Mar 28, 2019 7:59 pm
by Alburquenque
hi,
I'm working on a simulation of an air flow on a sphere inside a wind tunnel but I am having some problems at the time of the simulation.
the error message is

First face with boundary condition definition error
(out of 15000)
has boundary condition type 0, center (0.475, 0.1485, 0.00155)




cs_boundary_conditions.c:363: Fatal error.

create groups on faces, these groups are: inlet outlet, walls and simetry

thank you very much, greetings from chile.

Re: problems with boundary conditions

Posted: Thu Mar 28, 2019 10:17 pm
by Yvan Fournier
Hello,

Did you use the error postprocessing visualization to see which faces cause issues ?

The forum usage recommendations provide a more detailed list of information which can be useful to help solve the issue.

Regards,

Yvan