problems with boundary conditions

Questions and remarks about Code_Saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
Alburquenque
Posts: 5
Joined: Thu Mar 28, 2019 7:49 pm

problems with boundary conditions

Post by Alburquenque » Thu Mar 28, 2019 7:59 pm

hi,
I'm working on a simulation of an air flow on a sphere inside a wind tunnel but I am having some problems at the time of the simulation.
the error message is

First face with boundary condition definition error
(out of 15000)
has boundary condition type 0, center (0.475, 0.1485, 0.00155)




cs_boundary_conditions.c:363: Fatal error.

create groups on faces, these groups are: inlet outlet, walls and simetry

thank you very much, greetings from chile.

Yvan Fournier
Posts: 2625
Joined: Mon Feb 20, 2012 3:25 pm

Re: problems with boundary conditions

Post by Yvan Fournier » Thu Mar 28, 2019 10:17 pm

Hello,

Did you use the error postprocessing visualization to see which faces cause issues ?

The forum usage recommendations provide a more detailed list of information which can be useful to help solve the issue.

Regards,

Yvan

Post Reply