Hello,
i want to know use which Filters see the result about free surface mesh motion?
Regards,
Helmut
free surface in paraview
Forum rules
Please read the forum usage recommendations before posting.
Please read the forum usage recommendations before posting.
-
- Posts: 284
- Joined: Fri Dec 04, 2015 1:42 pm
Re: free surface in paraview
Hello,
I assume that you have a displacement vector as result of the CS simulation, so you can use the "warp by vector" filter. Also, you have a scale factor parameter to "scale" these displacement. Regards,
Luciano
I assume that you have a displacement vector as result of the CS simulation, so you can use the "warp by vector" filter. Also, you have a scale factor parameter to "scale" these displacement. Regards,
Luciano
-
- Posts: 15
- Joined: Wed Oct 25, 2017 1:51 am
Re: free surface in paraview
Hello Luciano,
I used your xml file, but in the postview processing, I didn't get the free surface effect. Is there a problem with my settings in paraview?
Best wishes
Helmut
I used your xml file, but in the postview processing, I didn't get the free surface effect. Is there a problem with my settings in paraview?
Best wishes
Helmut
-
- Posts: 284
- Joined: Fri Dec 04, 2015 1:42 pm
Re: free surface in paraview
Hello,
Check if in your XML file in the DATA directory there is a block of code like this for the BC_4
If there exist, remove it, and the run the simulation without saving in the GUI. Other option is to compare the two XML (the file that I upload and the file that you have in the DATA directory).
Regards,
Luciano
Check if in your XML file in the DATA directory there is a block of code like this for the BC_4
Code: Select all
<wall field_id="none" label="BC_4">
<ale choice="fixed_boundary"/>
</wall>
Regards,
Luciano