mesh for the turbomachinery

Questions and remarks about Code_Saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
Posts: 60
Joined: Fri Aug 04, 2017 11:02 pm

mesh for the turbomachinery

Post by yany » Fri Aug 18, 2017 4:39 pm

Hello Everyone,
I 'm now using the turbomachery module for a wind a turbine and I have a small question about the mesh.
The mesh of the rotor and stator should be have a gap ? Or their edges are overlap? For the wind turbine, in steady mode, the rotor and the stator(air) should be connect with each other.

All the best, Yan.

Post Reply