Problem of verifying the quality of the mesh in CS 5.0

Questions and remarks about code_saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
sante
Posts: 41
Joined: Thu May 14, 2015 1:09 am

Problem of verifying the quality of the mesh in CS 5.0

Post by sante »

hello,
Since I installed the new version of code_saturne(C_S-5.0). I can not verify my mesh in the GUI.


"Please i need help"

Best regards

Sante Junior.
Attachments
Absence of "mesh quality criteria" in the ENVIRONMENT CALCULATION option
Absence of "mesh quality criteria" in the ENVIRONMENT CALCULATION option
Luciano Garelli
Posts: 280
Joined: Fri Dec 04, 2015 1:42 pm

Re: Problem of verifying the quality of the mesh in CS 5.0

Post by Luciano Garelli »

Hello,

In CS 5 you have to switch to the "prepocessing mode" (in the fig that you post you are in the "calculation mode") and then select "mesh quality criteria" in the preprocessing type.
mesh_quality.jpg
Regards,

Luciano
sante
Posts: 41
Joined: Thu May 14, 2015 1:09 am

Re: Problem of verifying the quality of the mesh in CS 5.0

Post by sante »

Hello Luciano;

Thank you for your reply. Now I face another problem; When I want to load the boundary conditions I am asked for the file "check_mesh.log" which is absent. I do not know how to solve this new problem. Especially that I want to run a tutorial on burning pulverized coal with a Lagrangian approach.

Please, I still need your help

Regards

Sante Junior.
sante
Posts: 41
Joined: Thu May 14, 2015 1:09 am

Re: Problem of verifying the quality of the mesh in CS 5.0

Post by sante »

Hello,
Here is the mesh file of the tutriel in question.

Regards.

Sante Junior
Attachments
Tutorial3D.cgns.tar.gz
(454.22 KiB) Downloaded 197 times
Luciano Garelli
Posts: 280
Joined: Fri Dec 04, 2015 1:42 pm

Re: Problem of verifying the quality of the mesh in CS 5.0

Post by Luciano Garelli »

Hello,
The file that you have to read in order to load the BC's is the preprocessor.log as the pop-up notifications says.
preprocessor.png
Regards,

Luciano
sante
Posts: 41
Joined: Thu May 14, 2015 1:09 am

Re: Problem of verifying the quality of the mesh in CS 5.0

Post by sante »

Hello Luciano,
Thanks you!!!!

Best Grgards

Sante Junior
Post Reply