"Three 2D disks" coupled case ran only one iteration.

Questions and remarks about code_saturne usage
Forum rules
Please read the forum usage recommendations before posting.
Post Reply
ffan
Posts: 66
Joined: Thu Jul 24, 2014 3:23 pm

"Three 2D disks" coupled case ran only one iteration.

Post by ffan »

Dear Code_Saturne users and developers,

I tried the example case “Three 2D disks” following the instruction http://code-saturne.org/cms/sites/defau ... -disks.pdf
The fluid and the solid parts, separately, ran without a problem. However, the coupled case ran only one iteration before stopping. (The model is attached here.) Why did it run only one iteration? Thank you very much.

- ffan
Attachments
3disks2D.tar.gz
(4.79 MiB) Downloaded 157 times
Yvan Fournier
Posts: 4070
Joined: Mon Feb 20, 2012 3:25 pm

Re: "Three 2D disks" coupled case ran only one iteration.

Post by Yvan Fournier »

Hello,

I am not sure, but as it seems (accoring to your logs) that Syrthes is requesting the stop, you should try removing the syrthes.stop file in the Syrthes (solid) setup directory.

Regards,

Yvan
ffan
Posts: 66
Joined: Thu Jul 24, 2014 3:23 pm

Re: "Three 2D disks" coupled case ran only one iteration.

Post by ffan »

Yvan,

Thanks.

- ffan
Post Reply