About setting the Volumetric Source Term

This forum is dedicated to Syrthes related issues, as the Syrthes tool does not have its own forum.
Post Reply
Jundi He
Posts: 106
Joined: Fri Jan 13, 2017 3:23 pm

About setting the Volumetric Source Term

Post by Jundi He »

Hi,

I've run the solid case independently in Syrthes without any volumetric source term, and it just goes fine. But after I set a volumetric source term which is a heat generation term varies along axial (z) direction, and when I run the simulation, it failed. Is there some mistakes during my setting? It's just a simple function. Thank you!

Best Regards!
Jundi He
Attachments
run_the_simulation.png
volumetric_conditions.png
Luciano Garelli
Posts: 280
Joined: Fri Dec 04, 2015 1:42 pm

Re: About setting the Volumetric Source Term

Post by Luciano Garelli »

Hello Jundi He,

Did you solve the problem? If not check the stderr.txt file for more information. Also, you can check the in the user_fct.c file (void user_cfluvs_fct() ) if the data that you input throught the GUI were setted.

Regards,

Luciano
Jundi He
Posts: 106
Joined: Fri Jan 13, 2017 3:23 pm

Re: About setting the Volumetric Source Term

Post by Jundi He »

Hello, Luciano:

I did "solve" the problem, by replacing (z/8.32)^2 with (z/8.32)*(z/8.32), as I realized that the function complier doesn't recognise the "^". Thanks.

Best Regards!
Jundi He
Post Reply