code_saturne User's Forum

Hello Oscar, If I'm not misunderstanding your question you can retain the boundaries group through the the GUI of CS. You have to go to the "Mesh" tab In the "Calculation Control" -> "Output Control" section and there you can use the same selection criteria that you use...

Hello Oscar,

CS by default create the boundary domain with all boundary faces, but you can use the same selection criterion that you use for the BC to write specifics boundaries zones. This is done in the writer of the output control by adding new zones.

I hope that this help you.

Regards,

Luciano

Hello,

Could you post the case and mesh files in order to check It?

Regards,

Luciano

Hello,

Yes, you are right. Would be useful that the frozen field at the restart appear selected after Frozen carrier flow were selected. Maybe the developers has its reasons for doing in that way.

Regards,

Luciano

Hello, Frozen carrier flow is setted with the variable IILAGR=3, and the doxygen documentation mention "when IILAGR= 3 Lagrangian two-phase flow on frozen continuous phase. This option can only be used in case of a calculation restart. All the Eulerian fields are frozen (including the scalar fi...

Hello,

May be these articles can help you

http://www.iith.ac.in/~hdixit/papers/di ... cavity.pdf

http://www.sciencedirect.com/science/ar ... 309190025D

Regards,

Luciano

Hello Claude, What do you refer with "the junction is bad"? Are you doing the face joining in salome (build compound->merge coincident nodes and elements) or in CS (Face joining)?? I don't know how is your geometry, but you can use projection 1D2D in Salome in order to have the same mesh a...

Hello,

Did you try to reduce the Courant Number to get a Co~1..5?.
Looking at the figure that you posted, I think that you can do a structured mesh using 3D extrusion, doing a mesh for the diffuser, a mesh for the room and then gluing at the interface.

Regards,

Luciano

Hello,

I attach a screenshot about where you can set the output frequency.
Regards,

Luciano

Hello, Yes, you can select the frequency of the output in the writer tab on "Output Control". With respect to the energy balance you can define internal surfaces and integrate the variables or quantities, but also you can do during the post processing (this is what I did) in paravis/paravi...