Search found 17 matches

by cwinant
Thu May 28, 2020 12:48 am
Forum: code_saturne usage
Topic: Boundary Conditions
Replies: 10
Views: 6027

Boundary Conditions

In the case where BC on adjacent boundaries are different (for example wall and sliding wall), which condition is imposed at the intersection. To be clear in the Cavity totorial are the upper corner points moving or still? In a similar problem I need to impose a boundary condition on the normal grad...
by cwinant
Thu May 14, 2020 11:21 pm
Forum: code_saturne usage
Topic: Importing mesh into code_saturne 6.0
Replies: 4
Views: 3139

Re: Importing mesh into code_saturne 6.0

Hi Yvan Thanks so much for your prompt reply. There is another point you might consider clarifying: on line 6 of page 11 of the same document it says to "Click on the heading "Calculation management", but as you will see on Figure 2, there is no such heading. Many thanks to you and co...
by cwinant
Thu May 14, 2020 8:34 pm
Forum: code_saturne usage
Topic: Importing mesh into code_saturne 6.0
Replies: 4
Views: 3139

Re: Importing mesh into code_saturne 6.0

Hi Camille Following your instructions worked. I am very grateful to you. I have a further question regarding the instructions on pg 12 of the document Code_Saturne version 6.0.0 practical user's guide, middle of top para where it says to type the command line ./SaturneGUI setup.xml On a new case, I...
by cwinant
Thu May 14, 2020 2:56 am
Forum: code_saturne usage
Topic: Importing mesh into code_saturne 6.0
Replies: 4
Views: 3139

Importing mesh into code_saturne 6.0

I am running code_saturne 6.0 on debian bullseye. The code_saturne was installed from the debian package. I have a mesh file prepared by Salome in a directory Tutorial_1/Mesh_1/Mesh_1.med. I start code_saturne gui. I open a new case GTV/SmallChannel with MESH and POST directories. I open MESH which ...
by cwinant
Fri Apr 10, 2020 3:41 am
Forum: code_saturne usage
Topic: code-saturne salome and paraview
Replies: 1
Views: 1536

code-saturne salome and paraview

Please excuse this if it is off-topic. I have recently installed code-saturne from debian package running in debian install. The list of Topics printed to the console includes an item entitles salome, however when invoked it returns: abraca@GTV:~/Software/MPI$ code_saturne salome SALOME is not avail...
by cwinant
Thu Apr 09, 2020 12:55 am
Forum: Installation issues
Topic: code-saturne installed from debian package fails to start
Replies: 2
Views: 3021

Re: code-saturne installed from debian package fails to start

That does the trick. I am not sure how to send this bug report to the maintainer, so it would be best if you did that; telling me briefly how to do that would help me in the future and save you a little time?

I am so grateful
by cwinant
Wed Apr 08, 2020 10:18 pm
Forum: Installation issues
Topic: code-saturne installed from debian package fails to start
Replies: 2
Views: 3021

code-saturne installed from debian package fails to start

I am new to code-saturne. I am using debian bullseye, where the package code-saturne is available so sudo apt install code-saturnes loads a long list of packages, however when the program is invoked: abraca@GTV:~$ code_saturne Traceback (most recent call last): File "/usr/bin/code_saturne"...