Code_Saturne User's Forum

Success! I build a 3D model (coupling walls of a house to the volume inside) and got it working. See attached picture. As far as the 2D model.. I did build it from scratch but after opening the Syrthes example (solid-coupling.syd) after you mentioned it I saw what might have been the error. In the t...

Hi Yvan

I have attached the 2 log files from the coupled run. From the listing file it seems that code_saturne can not map the result to the Syrthes boundary? I assume 3d fluid to 2D solid is possible.

Not sure what you can make out from the logs. It looks like everything else is ok.

Regards,
Karl

and some more log files

Hello Yvan, No I do not have this problem in serial. Please see the attached listing files for cas3disk3d. I have asked for 5 steps and results for every time step. As I said it runs fine in parallel but only writes out the last result as shown in the listing. I have also attached all my install log...

Hi jb_l I have been following this post as I'm in the same boat as you. Have you managed to couple the two codes? I can also run both saturne and syrtes in serial and parallel but I am not able to run a coupled simulation. I believe it has something to do with my syrthes installation. If I run a syr...

Hi There, New to Syrthes. I installed Syrthes4.3.0 on Ubuntu 14.04 and everything seems to be working (except I did get an error during syrthes-post build, see attachement). The plan is to couple syrthes with Code_Saturne. I have run the cases in serial and in the POST directory I find the .rdt file...