code_saturne User's Forum

Hello,

I tried hard to find solution for inlet imposed pressure boundary condition. I understand that the only solution is to use subroutines. There is a topic http://code-saturne.org/forum/viewtopic.php?f=9&t=627 where the solution is shown.

When I paste this to my cs_user_boundary_conditions.f90 ...

Hello,

I got question not exactly connected with saturne, but this topic gave me an idea.

I did coupled analysis in syrthes/CS everything was ok, but I always had to mesh part with coincidence nodes on shared surfaces. I can see that there is a routine here but it doesn't work now on my computer ...

I checked coupling with syrthes and unfortunetly it doesn't work. I got this message:

[mw-workstation:04224] [[INVALID],INVALID] ORTE_ERROR_LOG: Not found in file ess_env_module.c at line 358
[mw-workstation:04221] tcp_peer_recv_connect_ack: invalid header type: 109051904
[mw-workstation:04224 ...

Sure it is in attachment.

I tried with version that was compiled with syrthes 4.3, then I tried with standalone scotch 6.0.4, because last version in repository is scotch 5.12 (saturne should work > 6.0)

I tried with automatical instalation - results was the same like early.

Finally I instaled it ...

Dear Yvan

I tried install Code saturne with scotch from syrthes 4.3 built (scotch 6.03) but there is still the smae error like in zihenwuming situation. I tired install from source scotch 6.04 but with the same result.

Do you maybe think that it is because of scotch 5.12 I got instaled from ...

Thank you very much for response:)

I will try saturne 3.3.4 and after 2 or 3 weeks I will change to new versions.

I am grateful for informations;)

Is there any possibility to fix that? I am not sure if 4.0 version will cooperate with syrthe 4.1.

Ok, problem solved, I set up everything one more time and now it does work.

Thank you very much;).

THank you for response.


Sory for doing mess, I am completly new in this forum, I don't know how to move topic to other setcion.

To precise my question refers to this part of tutorial-

ATTENTION
It may happen that a simulation won’t start due to :
syrthes: syr_cfd_coupling.c:1183: _interpolation ...

Hello to everyone


I got a question about last "attention"

I edited cs_user.c file, but I don't know how to run it. I turned off conjugate in syrthes gui and temperatures in saturne gui. If I use runcase I got same eroor like in attention.

Is that possibility to set coupling with not exactly ...